Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: wolf32 on January 04, 2020, 09:31:47 PM

Title: mach 4 testing limits and home switches inputs
Post by: wolf32 on January 04, 2020, 09:31:47 PM

hello

so im moving my machine from mach 3 to mach 4 its is a cnc router with a galil dmc 4080 controller and uses a gantry with dual motors i have limit switches at each end of the axis and proximity switches for the homes but i want to know is there some way i can test the limits and the homes like the diagnostic page we use to have in mach 3 were you could see what limits, homes, and other inputs were active?

thanks for your help

Title: Re: mach 4 testing limits and home switches inputs
Post by: Steve Stallings on January 04, 2020, 10:04:41 PM

Mach4 has a similar page, just look two tabs to the right of Program Run on the second line of tabs on the main screen. It is labeled "Machine Diagnostics"

Title: Re: mach 4 testing limits and home switches inputs
Post by: wolf32 on January 04, 2020, 10:21:28 PM

Quote from: Steve Stallings on January 04, 2020, 10:04:41 PM

Mach4 has a similar page, just look two tabs to the right of Program Run on the second line of tabs on the main screen. It is labeled "Machine Diagnostics"

thank you steve i turns out i had a different screen set on now i see the tab but again thank you very much time to setup these limits  ;D