Hello Guest it is January 20, 2020, 07:10:58 PM

Author Topic: CSMIO/IP-M and Mach3 Enable output issues  (Read 1237 times)

0 Members and 1 Guest are viewing this topic.

CSMIO/IP-M and Mach3 Enable output issues
« on: October 08, 2019, 04:25:17 AM »
Hi,

I'm trying to connect a Clearpath SDSK servo which requires a enable signal from Mach3 to energize it.

I have hooked up +24V to Pin9 and 0V to Pin22 (power for the outputs).

I'm using Output0 (Pin10) on the CSMIO and Port10 as the port.

I don't get any output signal. What am I missing?



Cheers,
« Last Edit: October 08, 2019, 04:27:07 AM by carlthomsen »
Re: CSMIO/IP-M and Mach3 Enable output issues
« Reply #1 on: October 08, 2019, 04:43:57 AM »
The Enable output in Mach3 lights up.

Offline TPS

*
  •  1,448 1,448
    • View Profile
Re: CSMIO/IP-M and Mach3 Enable output issues
« Reply #2 on: October 31, 2019, 02:38:16 AM »
is the OUT0 led on the CSMIO-M comming ON?
Output assigned in Config->Ports&Pins->Output Signals?
if yes, assigned to what?
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.