Machsupport Forum

Third party software and hardware support forums. => CS-Lab => Topic started by: carlthomsen on October 08, 2019, 04:25:17 AM

Title: CSMIO/IP-M and Mach3 Enable output issues
Post by: carlthomsen on October 08, 2019, 04:25:17 AM

Hi,

I'm trying to connect a Clearpath SDSK servo which requires a enable signal from Mach3 to energize it.

I have hooked up +24V to Pin9 and 0V to Pin22 (power for the outputs).

I'm using Output0 (Pin10) on the CSMIO and Port10 as the port.

I don't get any output signal. What am I missing?



Cheers,

Title: Re: CSMIO/IP-M and Mach3 Enable output issues
Post by: carlthomsen on October 08, 2019, 04:43:57 AM

The Enable output in Mach3 lights up.

Title: Re: CSMIO/IP-M and Mach3 Enable output issues
Post by: TPS on October 31, 2019, 02:38:16 AM

is the OUT0 led on the CSMIO-M comming ON?
Output assigned in Config->Ports&Pins->Output Signals?
if yes, assigned to what?