0 Members and 1 Guest are viewing this topic.
Thanks Graig, so after changing the reference point the machine has to make slow passes to learn. After teaching is runs normal
Quote from: Overloaded on September 13, 2019, 11:20:47 AMQuote from: joeaverage on September 10, 2019, 03:00:55 PMHi,when Mach starts it defaults to a low 6% of max speed.Craig.... actually, it defaults to 6.00 units per min.Inches would be quite "visible", but mm's would barely creep.Increase override 200% and that DRO goes to 12 What is showing in the attached pic while your machine is invisibly moving after hitting the "Go to Zero" button ?The set feedrate is 1000Units/min runs between 9000 and 10000Units/rev is 0
Quote from: joeaverage on September 10, 2019, 03:00:55 PMHi,when Mach starts it defaults to a low 6% of max speed.Craig.... actually, it defaults to 6.00 units per min.Inches would be quite "visible", but mm's would barely creep.Increase override 200% and that DRO goes to 12 What is showing in the attached pic while your machine is invisibly moving after hitting the "Go to Zero" button ?
Hi,when Mach starts it defaults to a low 6% of max speed.Craig
Quote from: Hanjelle on September 13, 2019, 04:49:54 PMThanks Graig, so after changing the reference point the machine has to make slow passes to learn. After teaching is runs normalAccording to your XML, your homing speeds are far faster than a creep.Should not be :"If I use the 'go to zero' button however the machine moves extremely slow. Almost invisible movement". (from your first post)
Quote from: Hanjelle on September 13, 2019, 01:39:19 PMQuote from: Overloaded on September 13, 2019, 11:20:47 AMQuote from: joeaverage on September 10, 2019, 03:00:55 PMHi,when Mach starts it defaults to a low 6% of max speed.Craig.... actually, it defaults to 6.00 units per min.Inches would be quite "visible", but mm's would barely creep.Increase override 200% and that DRO goes to 12 What is showing in the attached pic while your machine is invisibly moving after hitting the "Go to Zero" button ?The set feedrate is 1000Units/min runs between 9000 and 10000Units/rev is 0So, this is showing while the machine is going to zero after the button press ? ? ? and ... "If I use the 'go to zero' button however the machine moves extremely slow. Almost invisible movement."I'm at a loss here. Not sure what is going on .