0 Members and 1 Guest are viewing this topic.
"Go to Zero" is a system function within Mach3. I do not see any issues with your XML and it responds normally here.Perhaps it is associated with your "Xulifeng-Mach3-USB-Motion-Card", assuming there is a plugin for it.Looks good here otherwise.Regards,
Hi,when Mach starts it defaults to a low 6% of max speed.Craig
Quote from: joeaverage on September 10, 2019, 03:00:55 PMHi,when Mach starts it defaults to a low 6% of max speed.Craig.... actually, it defaults to 6.00 units per min.Inches would be quite "visible", but mm's would barely creep.Increase override 200% and that DRO goes to 12 What is showing in the attached pic while your machine is invisibly moving after hitting the "Go to Zero" button ?