Hi, I'm building a plasma table. I'm using Mach4 with the Hicon Integra 7766 board. I have the stepper motors all working properly but I cant find any documentation on wiring the plasma torch. Any help is greatly appreciated!

Hello,

Have you gone through this document http://www.vitalsystem.com/portal/cnc/motion/ArcProPlasmaGuide.pdf which talks about wiring the THC-150 Proma and the HiCON 7766 controller for Plasma Torch Height control (Page 5).

You can visit our Knowledge-base page http://www.vitalsystem.com/portal/support.php under 'ArcPro Plasma' has some good information about the THC sequence and signals.

You can mail support@vitalsystem.com for any further questions regarding this topic.

Let us know if the above answers your question.

Thanks! I'll check those links