Hello
Guest
it is
April 25, 2024, 11:39:28 PM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Third party software and hardware support forums.
/
HiCON Motion Controller
(Moderator:
Vital System Support
)
/
Hicon board wiring to fire plasma torch
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Hicon board wiring to fire plasma torch (Read 2493 times)
0 Members and 1 Guest are viewing this topic.
Route66Retro
2
Hicon board wiring to fire plasma torch
«
on:
September 05, 2019, 12:37:23 PM »
Hi, I'm building a plasma table. I'm using Mach4 with the Hicon Integra 7766 board. I have the stepper motors all working properly but I cant find any documentation on wiring the plasma torch. Any help is greatly appreciated!
Logged
Vital System Support
394
Re: Hicon board wiring to fire plasma torch
«
Reply #1 on:
September 05, 2019, 04:31:02 PM »
Hello,
Have you gone through this document
http://www.vitalsystem.com/portal/cnc/motion/ArcProPlasmaGuide.pdf
which talks about wiring the THC-150 Proma and the HiCON 7766 controller for Plasma Torch Height control (Page 5).
You can visit our Knowledge-base page
http://www.vitalsystem.com/portal/support.php
under 'ArcPro Plasma' has some good information about the THC sequence and signals.
You can mail support@vitalsystem.com for any further questions regarding this topic.
Let us know if the above answers your question.
Logged
Route66Retro
2
Re: Hicon board wiring to fire plasma torch
«
Reply #2 on:
September 05, 2019, 04:51:21 PM »
Thanks! I'll check those links
Logged
Print
Pages:
1
Go Up
« previous
next »