Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: Route66Retro on September 05, 2019, 12:37:23 PM
-
Hi, I'm building a plasma table. I'm using Mach4 with the Hicon Integra 7766 board. I have the stepper motors all working properly but I cant find any documentation on wiring the plasma torch. Any help is greatly appreciated!
-
Hello,
Have you gone through this document http://www.vitalsystem.com/portal/cnc/motion/ArcProPlasmaGuide.pdf (http://www.vitalsystem.com/portal/cnc/motion/ArcProPlasmaGuide.pdf) which talks about wiring the THC-150 Proma and the HiCON 7766 controller for Plasma Torch Height control (Page 5).
You can visit our Knowledge-base page http://www.vitalsystem.com/portal/support.php (http://www.vitalsystem.com/portal/support.php) under 'ArcPro Plasma' has some good information about the THC sequence and signals.
You can mail support@vitalsystem.com for any further questions regarding this topic.
Let us know if the above answers your question.
-
Thanks! I'll check those links