Hello Guest it is May 05, 2021, 05:29:06 PM

Author Topic: Need help configuring G-Rex pins in Mach3  (Read 4140 times)

0 Members and 1 Guest are viewing this topic.

Need help configuring G-Rex pins in Mach3
« on: September 09, 2007, 01:04:09 AM »
Can't find instructions for configuring the pin's for G-Rex.
Can someone direct me to where the info is?

Thanks

Bill

Offline Chaoticone

*
  • *
  •  5,626 5,626
  • Precision Chaos
    • View Profile
Re: Need help configuring G-Rex pins in Mach3
« Reply #1 on: September 09, 2007, 06:19:22 AM »
Several threads in this board about it. I will loook for you this evening and try to help if your not sorted by then.

Brett
« Last Edit: September 09, 2007, 06:27:24 AM by Chaoticone »
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Need help configuring G-Rex pins in Mach3
« Reply #2 on: September 09, 2007, 12:39:42 PM »
Thanks Brett.

Anything you can find would be a big help.

Bill

Offline Chaoticone

*
  • *
  •  5,626 5,626
  • Precision Chaos
    • View Profile
Re: Need help configuring G-Rex pins in Mach3
« Reply #3 on: September 09, 2007, 08:31:29 PM »
Hey Bill, sorry, I just got in from work. All inputs and outputs are set to port 1, pins are: 1-16 ins and outs are 1-16 on the g100 ins and outs. Your Home switches should be wired to the ones marked LIM for each axis. They are inputs 17-22, 17=x, 18=Y, 19=Z, 20=A, 21=B, 22=C.


Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Need help configuring G-Rex pins in Mach3
« Reply #4 on: September 09, 2007, 10:12:59 PM »
Thanks for the info Brett.
It's just what I needed.

Bill