Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: wmcook on September 09, 2007, 01:04:09 AM
-
Can't find instructions for configuring the pin's for G-Rex.
Can someone direct me to where the info is?
Thanks
Bill
-
Several threads in this board about it. I will loook for you this evening and try to help if your not sorted by then.
Brett
-
Thanks Brett.
Anything you can find would be a big help.
Bill
-
Hey Bill, sorry, I just got in from work. All inputs and outputs are set to port 1, pins are: 1-16 ins and outs are 1-16 on the g100 ins and outs. Your Home switches should be wired to the ones marked LIM for each axis. They are inputs 17-22, 17=x, 18=Y, 19=Z, 20=A, 21=B, 22=C.
Brett
-
Thanks for the info Brett.
It's just what I needed.
Bill