Hello at all,

Thanks for sharing this great UI.

It's looking much better than the 1024 UI.

Question:
You spend so much time in building good looking Backgroud-Pictures.
But: How do I have to set up MACH3 that the Background-Picture is displayed without scaling?
I always get some bad looking . (I think it is form scaling the Background***.png Pictures)

Hi Kissling,

Sorry, I'm no longer working on that project. However, I will tell you that I had to rescale the backgrounds using Photoshop to natively fit my relatively low resolution Lenovo all-in-one PC on my mill. I used a combination of Photoshop, Illustrator and Machscreen to design/create/modify all of the other graphics in the UI.

I would try adjusting the UI in Machscreen since you can adjust the placement of the graphics/buttons/LEDs/DROs if necessary.

I hope that helps.

Good luck!

dotyman

Hello Dotyman, I really like your interface, but the "SHORTCUTS" don't work, right? I'm trying to load a new G-Code with "CTRL + L" and it doesn't work...

Greetings.

Hi JoeBar,

Shortcuts should work, just make sure you're on the appropriate screen/page. I just checked and the CTRL +L works to load a G-code file on my PC as long as I'm on the PROGRAM page in Mach.

Hope that helps!

Dotyman