Hi,
the manual suggests that the controller uses a genuine USB controller, an XHC USB-Pod, oh joy....yet another
XHC......
You have installed the parallel port driver as evidenced by the DriverTest.exe pic you posted earlier but you don't need it.
You have an external controller.
Look in Mach3/Plugins folder to see if there is a .dll file that pertains to the XHC controller. If so open Mach and select that
device as motion controller.
Once you have got that running......and with a few hundred dollars worth of gut-rot whiskey or other sedative of your choice.....
throw the XHC away and get a genuine Ethernet SmoothStepper or a UC300, THEN you can start to do some decent
CNCing.
Good luck.
Craig