Hi ArtSoft Community!
Im having a little mishap. I uninstalled Mach 3 and reinstalled it hoping it would fix a little problem I was having. It then led me to another little road block...
When I Load in a G-code into mach 3 and cycle start, it loads a codes and starts at Z0.0370 and gradually cuts to my set start and cut depth which is Z-0.0130 which I preset in lazy cam.
Ive attached a photo below circling the code in the log and 3D view of my CAD in the screen viewer. it also shows the line the goes downward...
Any help will be GREATLY appreciated!!!
Thank you