Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: lukekanahele on April 17, 2019, 10:46:51 PM
-
Hi ArtSoft Community!
Im having a little mishap. I uninstalled Mach 3 and reinstalled it hoping it would fix a little problem I was having. It then led me to another little road block...
When I Load in a G-code into mach 3 and cycle start, it loads a codes and starts at Z0.0370 and gradually cuts to my set start and cut depth which is Z-0.0130 which I preset in lazy cam.
Ive attached a photo below circling the code in the log and 3D view of my CAD in the screen viewer. it also shows the line the goes downward...
Any help will be GREATLY appreciated!!!
Thank you
-
What's wrong?
Tool is being fed downwards smoothly in "spiral" fashion as a leadin to profile CUTTING.
If you are trying to do fixed-depth pocketing in Lazycam, you need to have a "lazycam pro" license.
-
I would strongly suggest that you read / study the LazyCam Manual if you are going to use it.
RICH