had a look to the Manuals:
-HY-DIV268N
EN +: offline can reset signal input side is
EN-: offline can reset signal input negative terminal
Offline enable signal is active, reset drive failure to prohibit any pulse, the output of the drive Power component is turned off, the motor holding torque.
-DQ542MA
ENBL+ is the positive end of direction input pin. This signal is used for
enabling/disabling the driver. High level for enabling the driver and low level for disabling the driver.
ENBL- is the negative end of direction input pin. Usually left unconnected (enabled)
so it Looks like the enable signals are oposite.
check enable on the DQ542MA to be high if you want run the motor