Hello
I recently upgraded my PC. My old PC was just too old and slow. I don't have all the hardware specs handy at the moment, but I would like to get a few questions out there.
So I am running windows 7 32 bit with sp1 installed.
The processor is an I5 seventh generation.
Parallel Port is a PCI card.
When I installed mach 3 and fired it up on the PC, it immediately crashed and rebooted. I tried a couple more times and had the same result.
I read about 2 windows 7 updates that could cause this, neither one are installed on my computer. I'm not sure where to go from here.
Will mach 3 work with a pci parallel port?
Will mach 4 work with a pci parallel port using Darwin and windows 7?
Any other Ideas why windows 7 is crashing when firing up mach 3?
I will continue digging but was hoping maybe you guys could get me on the right path.
Thanks
Nick