Thank you so much cncNor!!!!!! It worked! Success!!!!
So it touches off just how i wanted without the use of arc ok wires.....

So only torch on and off and touch off! 😁👍

Yup, that is how I designed it to work. Glad you got it sorted. 

Now you should be able to use the up and down buttons in the lower THC panel to jog the Z up and down manually as it is cutting. So, you can adjust your cut height on the fly. You can do the same thing manually that a THC does automatically. 

Thank you so much for your help there's just one thing though does it matter if my Z axis isn't assigned to motor to in the Mach configuration? Because I just have motor 0 and slave is one motor to use my y axis and motor 3 is my Z axis

Have a look in your C:\Mach4Hobby\Docs folder, Plasma_Configuration.pdf. That is covered on page 2 and 3.

Quick question my guy...

Does youre set up adjust automatically to any distance change between torch and material when using the rouch off feature?

I was given a few tips to input in my machb4 software but im not getting auto adjustments when touching off when it moves to another area on material thats closer/ further away....

Any help?