Hello Guest it is March 28, 2024, 05:46:16 AM

Author Topic: Does anyone have a "Firmware" (post processor) file for Simplify3D to Mach4?  (Read 1106 times)

0 Members and 1 Guest are viewing this topic.

Offline poppabear

*
  • *
  •  2,235 2,235
  • Briceville, TN, USA
    • View Profile
Does anyone have a "Firmware" (post processor) file for Simplify3D to Mach4?

Thanks in advance.
fun times
Hi poppabear,
if you have a post that produces good Gcode for Mach3 then it should work for Mach4 also.

I have encountered only one instance where code that runs on Mach3 fails under Mach4. Even then its
because Mach4 sticks more closely to ANSI Gcode.

Craig
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'

Offline poppabear

*
  • *
  •  2,235 2,235
  • Briceville, TN, USA
    • View Profile
Hi Joe,
Thanks, but not really what I am asking/looking for, I need a "Simplify3D" Post processor (firmware file),
for the CAM software for out put to Mach4. I am very familiar with both mach3 & 4 as far as
what and how they run. I was/am hoping some one has the post so I do not have to recreate it,
since it is a PIA.
fun times
Hi,
so you don't have a Simplify3D post for Mach3 either?

Craig
« Last Edit: September 07, 2019, 04:14:55 PM by joeaverage »
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'