0 Members and 1 Guest are viewing this topic.
this is the only part witch is urgent for now:Quote from: TPS on February 15, 2018, 12:03:56 PMNotes: When in THC mode, motion will not begin until THCON (Torch OK) signal becomes active.
Notes: When in THC mode, motion will not begin until THCON (Torch OK) signal becomes active.
Torch/code freezes after M03....That is correct behaviour - the the torch is firing on the M03 signal BUT mach3 is NOT seeing an Arc-Ok signal so it will NOT move at all.The Proma is either not sending or not seeing the arc-ok.As a test, go ports&pins and disable Arc-Ok IIRC this should let it move without seeing the signal.