Hi,
my machine has Windows7 Embedded Standard 32 bit, has been fine.
Until recently my laptop was Windows8 but it had a meltdown. As I had a licence for Windows7 Embedded I loaded
that onto my laptop, 32 bit. May have been a mistake, only effectively have 2.5G RAM despite 8 G being fitted.
Have had trouble trying to fire up Machs Lathe profile.
Will over the weekend try my machine just to see whether the 32bit Windows7 Emmbedded is adequate to allow
Machs Lathe profile to load.
It seems that the GUI load but my laptop trips up when loading the canned cycle module and the lathe panel.
Have yet to work out how to overcome that limitation, it does load OK from time to time, and once it loads it runs
fine. I have to hold my tongue to the left!
Craig