Hi all,

Been away from the CNC for a few months due to work and moving house.  Also had to reinstall Mach3 on to a new PC, as the old
one failed.  I have got most of the setup done but now have a few issues with the configuration.  I'll post these as separate topics.

But I'm puzzled with the first one.  I guess this is a two-part query...When I enter M3 in the MDI (to test the spindle), I get an error
message about '#Expand File Not Found at.......Copyright & Licence Notice'?  M3 also doesn't work.  What is this 'Copyright & Licence Notice'?

I do have a valid licence, two in actual fact...one purchased within the last month.

This is an error message from the MachStdMill Screenset. It's either been installed, or uninstalled, incorrectly.

Ah, thanks Gerry.  Yes...I did have MachStdMill screenset a few years back but not sure where it's coming from.  I'll check my directories
to see if I copied over any reference to it.

That said, if I can't find any, could you suggest how I get around the problem and why the M3 command doesn't work?

OK...I have resolved the issue.  I have found a backup of the Screenset Macros and reinstalled them.