Hello Guest it is September 21, 2023, 11:50:16 PM

Author Topic: Copyright notice error  (Read 1552 times)

0 Members and 1 Guest are viewing this topic.

Copyright notice error
« on: December 08, 2017, 03:42:11 AM »
Hi all,

Been away from the CNC for a few months due to work and moving house.  Also had to reinstall Mach3 on to a new PC, as the old
one failed.  I have got most of the setup done but now have a few issues with the configuration.  I'll post these as separate topics.

But I'm puzzled with the first one.  I guess this is a two-part query...When I enter M3 in the MDI (to test the spindle), I get an error
message about '#Expand File Not Found at.......Copyright & Licence Notice'?  M3 also doesn't work.  What is this 'Copyright & Licence Notice'?

I do have a valid licence, two in actual fact...one purchased within the last month.

Offline ger21

  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Copyright notice error
« Reply #1 on: December 08, 2017, 06:44:14 AM »
This is an error message from the MachStdMill Screenset. It's either been installed, or uninstalled, incorrectly.

2010 Screenset

JointCAM Dovetail and Box Joint software
Re: Copyright notice error
« Reply #2 on: December 08, 2017, 07:51:45 AM »
Ah, thanks Gerry.  Yes...I did have MachStdMill screenset a few years back but not sure where it's coming from.  I'll check my directories
to see if I copied over any reference to it.

That said, if I can't find any, could you suggest how I get around the problem and why the M3 command doesn't work?
Re: Copyright notice error
« Reply #3 on: December 08, 2017, 01:04:40 PM »
OK...I have resolved the issue.  I have found a backup of the Screenset Macros and reinstalled them.