Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: krsykes23 on December 08, 2017, 03:42:11 AM
-
Hi all,
Been away from the CNC for a few months due to work and moving house. Also had to reinstall Mach3 on to a new PC, as the old
one failed. I have got most of the setup done but now have a few issues with the configuration. I'll post these as separate topics.
But I'm puzzled with the first one. I guess this is a two-part query...When I enter M3 in the MDI (to test the spindle), I get an error
message about '#Expand File Not Found at.......Copyright & Licence Notice'? M3 also doesn't work. What is this 'Copyright & Licence Notice'?
I do have a valid licence, two in actual fact...one purchased within the last month.
-
This is an error message from the MachStdMill Screenset. It's either been installed, or uninstalled, incorrectly.
-
Ah, thanks Gerry. Yes...I did have MachStdMill screenset a few years back but not sure where it's coming from. I'll check my directories
to see if I copied over any reference to it.
That said, if I can't find any, could you suggest how I get around the problem and why the M3 command doesn't work?
-
OK...I have resolved the issue. I have found a backup of the Screenset Macros and reinstalled them.