Chaoticone,
Thanks for the reply.
I decided to make one more test.
Instead of calculating an optimized G-Code on all the lines at once, I decided to do each line separately in Rhino/madCAM and optimize each line separately, but output it as one G-Code.
I tested one with CV .001mm Tolerance and the other all Angles at 100 keeping the G1 and G0 as is.
This method no longer has the off line movements on going from G1 to G0, but does takes a bit more time, however a lot less than all G1.
So for lettering this is the way to go.
The result in the DOC.
Regards,
Mauri.