Hello Guest it is March 28, 2024, 04:52:17 AM

Author Topic: LCAM ????  (Read 3578 times)

0 Members and 1 Guest are viewing this topic.

vmax549

*
LCAM ????
« on: March 20, 2006, 03:15:48 PM »
Brian I cannot get lcam to write a multipass file. It looks good in the Lcam display. But when it post the Gcode the multipass coding is not there. It plunges in a multistep mode but tries to cut everthing in one pass.
Re: LCAM ????
« Reply #1 on: March 20, 2006, 04:39:24 PM »
I will have a look at it ...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: LCAM ????
« Reply #2 on: March 24, 2006, 01:11:14 AM »
This might be a stupid question but when you do the updates to the program does it go into the 1.0 program on the artsoft site?
Re: LCAM ????
« Reply #3 on: March 24, 2006, 05:07:43 AM »
Yes that is where the update goes :) and that is not a dumb question ...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com