Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: vmax549 on March 20, 2006, 03:15:48 PM
-
Brian I cannot get lcam to write a multipass file. It looks good in the Lcam display. But when it post the Gcode the multipass coding is not there. It plunges in a multistep mode but tries to cut everthing in one pass.
-
I will have a look at it ...
-
This might be a stupid question but when you do the updates to the program does it go into the 1.0 program on the artsoft site?
-
Yes that is where the update goes :) and that is not a dumb question ...