Hello Guest it is December 12, 2019, 01:20:02 PM

Author Topic: Tuning Slaved Axes Motors  (Read 605 times)

0 Members and 1 Guest are viewing this topic.

Tuning Slaved Axes Motors
« on: June 23, 2017, 02:00:23 AM »
What is the procedure for tuning the two motors of a slaved axes? Do I tune each motor individually while unhooked from the axes? Or do I tune the motors while hooked up to the axes (gantry)? Should the velocity, acceleration, etc numbers (of the two identical motors) on the Motor Tuning Config pages be the same?

Thanks,
Villa

Offline Tweakie.CNC

*
  • *
  •  8,021 8,021
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Tuning Slaved Axes Motors
« Reply #1 on: June 23, 2017, 02:18:33 AM »
Quote
Should the velocity, acceleration, etc numbers (of the two identical motors) on the Motor Tuning Config pages be the same?

They must be the same.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.