Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: xxo04358 on June 23, 2017, 02:00:23 AM
-
What is the procedure for tuning the two motors of a slaved axes? Do I tune each motor individually while unhooked from the axes? Or do I tune the motors while hooked up to the axes (gantry)? Should the velocity, acceleration, etc numbers (of the two identical motors) on the Motor Tuning Config pages be the same?
Thanks,
Villa
-
Should the velocity, acceleration, etc numbers (of the two identical motors) on the Motor Tuning Config pages be the same?
They must be the same.
Tweakie.