Hi, Bought Mach4 yesterday and i do like it for now as i still doing some setup, Have connected the mister on relay, and dust collector (not assigned an M code yet)
Homing works great, probing doesnt (and lots have problems with it)
But what is really annoying is:
If i do homing, I have to push reset after
If i use an MDI command, i need to reset after
If i run a test file i need to reset... guess you see the point by now.
Also, when i do run some of my older files in "Airmode" for testing, it kinda stops on M codes all the time.. then i have to push reset and then Cycle start again.. This cant be right ?
I noticed this between 2 different cuts on one file, One was roughing and next one was a finnishing cut.. and it stopped after roughing and didnt continue with the finnishing cut.. i then had to push reset and then cycle start again.
The file doesnt change tool or anything, only cut speed and dept mainly..
Also, anyone got a toolchange script like the 2010 screenset for mach3 ? Anyone working on it ?