Hello Guest it is November 22, 2019, 08:55:21 PM

Author Topic: Change from parallel to ESS SmoothStepper  (Read 2539 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  8,009 8,009
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Change from parallel to ESS SmoothStepper
« Reply #20 on: May 07, 2017, 06:43:21 AM »
Hi Steve,

Excellent news my friend.

On the Settings (Alt_6) page there is the Axis Calibration feature. You could use this just to check that you have set your axis Steps per Unit correctly. Just follow the on-screen instructions.

On the main page are the Axis Scale DRO's. If, for example you changed both the X axis and Y axis Scale DRO's to +2.0000 (press return after each change) then the part would be made double size. Using these DRO's a part could be made to any scale size or 'flipped' by using a negative value for one axis. The possibilities are many.

Tweakie. 
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.