I'm having lots of trouble with my 8 Position Turret on my TCL160
I have searched the forums up and down in the hope of finding the correct information from what I can see, I think the M6start was written by Hood (Forgive me if I'm wrong)
Calling tools from the MDI line works for all the tools entered, however the movement of the Turret is inconsistent. Also If I enter G0 A360 I would expect the turret to rotate 360 Degrees, It doesn't.
I try repeated G0 A45 in an attempt to get the turret to rotate 45 degrees each time but I get inconsistent moves.
I also installed a Homing sensor to the turret but that does not seem to help, each time I home the Turret the DR) does not reset to 0 which is what I would expect?
It's sometimes behave as though it's a 6 tool turret ?
I have tried many variations of Steps/per in motor tuning but that did not help, tried 33.33, 66.66 etc etc, no luck
I have attached both my XML and M6start files so if anyone can spare a wee bit time having a look I would be very grateful, someone out there has got a machine with an 8 way turret working correctly. If M6Start macro is not the best way, what is?
Many thanks
George
Where am I going wrong ??