Hello Guest it is March 28, 2024, 04:18:21 PM

Author Topic: Mach3 safety switch wiring  (Read 1727 times)

0 Members and 1 Guest are viewing this topic.

Mach3 safety switch wiring
« on: February 22, 2017, 08:55:31 PM »
I am using a N/O switch. One leg connected ground other leg connected to pin input pin 2.  Just. Testing one switch nothing happens.
Have inport pin one and pin is #2.   Active low.  Please advise where I am going wrong.

Thank you
 

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Re: Mach3 safety switch wiring
« Reply #1 on: February 23, 2017, 02:10:35 AM »
Does your BOB work that way or does it need say one pin to 5v and the other to the input - pull up or pull down
Re: Mach3 safety switch wiring
« Reply #2 on: February 23, 2017, 06:58:13 AM »
Do not know what BOB means.

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Re: Mach3 safety switch wiring
« Reply #3 on: February 23, 2017, 07:17:57 AM »
Apologies, BOB = Break Out Board = the board that connects your inputs / outputs to your PC
Re: Mach3 safety switch wiring
« Reply #4 on: February 23, 2017, 09:47:16 AM »
For some reason I am unable to upload imiges.