Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kutton on February 22, 2017, 08:55:31 PM
-
I am using a N/O switch. One leg connected ground other leg connected to pin input pin 2. Just. Testing one switch nothing happens.
Have inport pin one and pin is #2. Active low. Please advise where I am going wrong.
Thank you
-
Does your BOB work that way or does it need say one pin to 5v and the other to the input - pull up or pull down
-
Do not know what BOB means.
-
Apologies, BOB = Break Out Board = the board that connects your inputs / outputs to your PC
-
For some reason I am unable to upload imiges.