I am new to Mach3 and CNC Routing. I would like to pay someone to help me setup the system.
I have most everything working but have questions on the following.
Spindle speed does not seem to be correct, it should be 24K, but only goes to 4 or 5K, from the DRO's
I have a smooth stepper controller, and a 3.2KW water cooled spindle
I have x,y,z set, but would like help with tuning them for better performance.
I would like advice on Work holding ideas, and would like to surface the spoil board, and create a part.
I can work anytime day or night.