Hello Guest it is March 28, 2024, 06:33:05 PM

Author Topic: New to Mach3, new 4x8 table, would like some help getting it setup, USA  (Read 5280 times)

0 Members and 1 Guest are viewing this topic.

I am new to Mach3 and CNC Routing. I would like to pay someone to help me setup the system.

I have most everything working but have questions on the following.

Spindle speed does not seem to be correct, it should be 24K, but only goes to 4 or 5K, from the DRO's

I have a smooth stepper controller, and a 3.2KW water cooled spindle

I have x,y,z set, but would like help with tuning them for better performance.

I would like advice on Work holding ideas, and would like to surface the spoil board, and create a part.

I can work anytime day or night.
« Last Edit: December 18, 2016, 11:36:06 AM by bbourdage »

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: New to Mach3, new 4x8 table, would like some help getting it setup, USA
« Reply #1 on: December 18, 2016, 06:38:23 PM »
Where are you located?
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: New to Mach3, new 4x8 table, would like some help getting it setup, USA
« Reply #2 on: December 18, 2016, 07:22:39 PM »
Geneva, Il