Hi
Finally almost there on my set up, one last issue. I have a rectangle work area 24" x 96" my home is the bottom left corner. When I ref all, all axis home fine to the home spot. I load the road runner to test out the system it loads in the bottom left corner fine. I push start and the machine try's to move in opposite direction of the work, and out of my table workspace.
Went to homing and limits page to uncheck and reverse X but all it does is move my home to right hand corner. How or what do I change to orient my movement in the proper direction. I don't know if this issue is affecting my Y and Z because off the direction movement it trips my limits right away.
Many thanks Bill