Hello Guest it is November 12, 2019, 10:54:49 AM

Author Topic: Requirements parallel port  (Read 2109 times)

0 Members and 1 Guest are viewing this topic.

Requirements parallel port
« on: May 11, 2016, 12:25:33 PM »
Hello,

Is there a possibilty to check in advance, whether the parallel port of an old notebook is suitable however? My CNC 3040 is on its way, and I'm wondering if there are some parameters, maybe vivible in the system controls, which I could check before ordering a PCMCIA card.

Thank you very much.
Thomas

Offline Tweakie.CNC

*
  • *
  •  7,984 7,984
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Requirements parallel port
« Reply #1 on: May 11, 2016, 12:37:09 PM »
I doubt it, however, install Mach3 then run the DriverTest and see what results you get - you may be lucky.

Tweakie
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.