Author Topic: WANTED Boxford TCL160 SGS GS-D200S Thomson Driver Board  (Read 4117 times)

0 Members and 1 Guest are viewing this topic.

Offline jackrusse11

  • Active Member
  • Posts: 4
    • View Profile
WANTED Boxford TCL160 SGS GS-D200S Thomson Driver Board
« on: May 01, 2016, 03:37:41 PM »
Good day,
Looking for a SGS GS-D200S Thomson Driver Board complete.  Must be able to drive 3 axes.
As was fitted to Boxford TCL lathe, and possibly a Denford Mirac lathe.
I have attached a photo similar to what is required.

UK ONLY PLEASE

Thanks
« Last Edit: May 01, 2016, 03:55:07 PM by jackrusse11 »

Offline Len-Tikular

  • Active Member
  • Posts: 147
    • View Profile
Re: WANTED Boxford TCL160 SGS GS-D200S Thomson Driver Board
« Reply #1 on: February 10, 2017, 09:20:50 AM »
Hope you got your board, sorry cant help,

I have a Boxford TCL160 benchtop lathe which I am converting.

I notice that the 'Spindle motor' has two light blue wires in the motor harness, they are marked 11 & 12.
These are in addition to the usual wires STF,STR etc etc.

Can you help?

George

Offline jetrebel

  • Active Member
  • Posts: 12
    • View Profile
Re: WANTED Boxford TCL160 SGS GS-D200S Thomson Driver Board
« Reply #2 on: May 28, 2017, 07:36:14 AM »
old post I know but if you still need one I think I have one here.

Jason

Offline jackrusse11

  • Active Member
  • Posts: 4
    • View Profile
Re: WANTED Boxford TCL160 SGS GS-D200S Thomson Driver Board
« Reply #3 on: July 13, 2017, 10:26:01 AM »
Hello Jetrebel
I found one off that online website that nobody mentions but everyone uses.
Thanks anyway.