Machsupport Forum
Tangent Corner => Bargain Basement => Topic started by: jackrusse11 on May 01, 2016, 03:37:41 PM
-
Good day,
Looking for a SGS GS-D200S Thomson Driver Board complete. Must be able to drive 3 axes.
As was fitted to Boxford TCL lathe, and possibly a Denford Mirac lathe.
I have attached a photo similar to what is required.
UK ONLY PLEASE
Thanks
-
Hope you got your board, sorry cant help,
I have a Boxford TCL160 benchtop lathe which I am converting.
I notice that the 'Spindle motor' has two light blue wires in the motor harness, they are marked 11 & 12.
These are in addition to the usual wires STF,STR etc etc.
Can you help?
George
-
old post I know but if you still need one I think I have one here.
Jason
-
Hello Jetrebel
I found one off that online website that nobody mentions but everyone uses.
Thanks anyway.