Hello Guest it is March 28, 2024, 05:41:09 PM

Author Topic: Motor tuning setup - Need help  (Read 3143 times)

0 Members and 1 Guest are viewing this topic.

Motor tuning setup - Need help
« on: February 13, 2016, 02:38:39 PM »
Hi All

I have a DM542A driver and nema 23 425oz.

I need to put the right parameters in mach3, motor tuning.

I am not sure which settings that are the best. For this setup

Can anyone help on the track, thanks.
Re: Motor tuning setup - Need help
« Reply #1 on: February 13, 2016, 03:05:49 PM »
http://www.machsupport.com/help-learning/product-manuals/

Its all in there.
Please post again if you have specific issues that you can't seem to resolve.

Russ  :)
Re: Motor tuning setup - Need help
« Reply #2 on: February 17, 2016, 04:54:16 PM »
I have collected some information about the equipment.

Can someone help to put all this together.


Nema 23 425oz
Step angel 1.8"
Current 3A
Shaft 8mm

DM542A
SW 1, 2, 3 on, on, off
4 off
SW 5, 6, 7, 8
Can be
400, 800, 1600, 3200 and so on....
I don't know which one to choose

Trapez 12mm
Pitch 3mm from top to top

But how do I calculate all this information correct.

So it fit in mach3?

Am I still missing something
Re: Motor tuning setup - Need help
« Reply #3 on: February 17, 2016, 06:00:27 PM »
Step angle 1.8 = 200 pulses per revolution
Set the switches for 2000 micro stepping
3mm pitch screw

2000 / 3 = 666.66666666666666 steps per unit (mm)

Re: Motor tuning setup - Need help
« Reply #4 on: February 17, 2016, 06:05:16 PM »
Thanks for your reply...

I was getting 533 or 1066, so something may I have done wrong.

Now I will take a closer look at your post.