Hello Guest it is August 12, 2025, 12:38:16 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach3  (Read 3781 times)

0 Members and 2 Guests are viewing this topic.

Offline plcamp

*
  • 4 4
Mach3
« on: September 27, 2015, 07:03:36 AM »
Does Mach3 have the ability to rotate or mirror cutter path?

Paul
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Mach3
« Reply #1 on: September 27, 2015, 03:03:25 PM »
Paul,
Have a read of the Mach manual, lost s of good info in it.

You can rotate an axis with G68 and mirror using a (-) in the scale input, if  I recall correctly , see also G51 command.

RICH
Logged

Offline plcamp

*
  • 4 4
Re: Mach3
« Reply #2 on: September 28, 2015, 07:57:35 AM »
Quote from: RICH on September 27, 2015, 03:03:25 PM
Paul,
Have a read of the Mach manual, lost s of good info in it.

You can rotate an axis with G68 and mirror using a (-) in the scale input, if  I recall correctly , see also G51 command.

RICH

Honestly I have not read the manual beyond my intital startup, but I will do it now.  Thank you for the quick response.

Paul
Logged
Pages: 1   Go Up
« previous next »