Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: plcamp on September 27, 2015, 07:03:36 AM
-
Does Mach3 have the ability to rotate or mirror cutter path?
Paul
-
Paul,
Have a read of the Mach manual, lost s of good info in it.
You can rotate an axis with G68 and mirror using a (-) in the scale input, if I recall correctly , see also G51 command.
RICH
-
Paul,
Have a read of the Mach manual, lost s of good info in it.
You can rotate an axis with G68 and mirror using a (-) in the scale input, if I recall correctly , see also G51 command.
RICH
Honestly I have not read the manual beyond my intital startup, but I will do it now. Thank you for the quick response.
Paul