Hi All
i have a problem..
Mach3 will not "RUN FROM HERE" at any line number over approx 160000. it works fine with anything up to this but after it locks out the RESET button around line162000.
As i have started to do some large 3D pieces with Aspire. this can be very frustrating when something goes wrong or a power blip knocks out the PC as the models i am cutting have 1million+ lines of code.
the latest (still on the machine bed hoping for a solution) was 97% complete or 5 1/2 hours of cutting when the power went off at around line 902000 !!!
does anyone know a solution to this ?
cheers
Dave
Pc
3ghz Pentium 4 with 2 gig ram
win XP service pack 2 (clean install with nothing but Mach3)
no network installed
iv attached some files