Hello Guest it is March 29, 2024, 01:13:09 AM

Author Topic: Can load be speeded up in my case?  (Read 1650 times)

0 Members and 1 Guest are viewing this topic.

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Can load be speeded up in my case?
« on: September 23, 2015, 03:51:18 AM »
Probably something i have not set right but...

When I load code, it runs through each line on screen, then when i press my "set origin" button it re-runs the whole lot again.

This can take some time on a full sheet, am i doing something odd or is this normal behaviour for Mach3??



BTW my set origin button (i think) copies the current position to a G54, then zero's the DROs then regens the toolpath display, basically makes wherever i stick the torch my zero point.

Offline BR549

*
  •  6,965 6,965
    • View Profile
Re: Can load be speeded up in my case?
« Reply #1 on: September 23, 2015, 10:06:02 AM »
Setup your Point of origin first THEN load your program. OR just create a new button that just zeros teh XYZ. I believe if you just zero the xyz then it will not regen.

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Re: Can load be speeded up in my case?
« Reply #2 on: September 23, 2015, 10:18:09 AM »
Setup your Point of origin first THEN load your program. OR just create a new button that just zeros teh XYZ. I believe if you just zero the xyz then it will not regen.

That sounds good, thanks