Who knows if it supports M10/M11 and EXP0/EXP1 command?
I use CSMIO/IP-M and assign Output#5 signal to PORT10 PIN1. But command M10 (ActivateSignal(11)) or M11(DeActivateSignal(11)) does not work. OUTPUT1 change state if I select/deselect "ActiveLow", but not respond to command.
Thanks!!!

Hi,

M10/M11 are used with Parameter

M11P5 means output ON
M10P5 means output OFF

nothing additional needed in macro M10.M1S and M11.M1S.

Thomas

Hi thanks for the fast reply!
Can I use E5P1 and E5P0 command for this?

Hi thanks for the fast reply!
Can I use E5P1 and E5P0 command for this?

sorry not idea what E5P1 and E5P0 should do.

Thomas

OK, In any case Thanks a lot!
I use command E5P0 and E5P1 for THC ON/OFF control from G-Code. This commands is no issue pause in motion.
And M10/M11 too, I hope.

Hi Thomas!
M11P5 and M10P5 is not work for me. I am assign for Mach3 Output#5  Port10 pin 4 for Output4 of the CSMIO.
Output state in the CSMIO IO diagnostic window change if I check/uncheck ActiveLow. But from G-Code M11P5 /M10P5 not changing of the state.
Can you check it's?
Thanks!!!

Hi,

it is working here (PP driver).

only thing i did is in CONFIG -> ports&pins -> mill option -> allow THC functions when not enabled.

Thomas

Thomas, this is CS-Lab thread and I think you use CSMIO. Yes in PP all work fine.

I send the message to CSMIO support about this question.
My THC controller is not use internal Mach3 THC  function, but I need this signal for control THC ON/OFF during execution of the G-Code.

Hi Andrew,

here in the CSMIO tutorial about THC

http://www.cs-lab.eu/en/index.php?m=article&s=main&aid=146&uinfo=THC_Analog_function

they are talking about to use M3/M5 for THC ON/OFF


my testmachine in office is PP port, i will test this evening on the CSMIO machine.

Thomas