Hello Guest it is March 28, 2024, 07:22:59 AM

Author Topic: Mach3 Windows 7 64bit with UC100- NEED HELP!!!  (Read 2905 times)

0 Members and 1 Guest are viewing this topic.

Mach3 Windows 7 64bit with UC100- NEED HELP!!!
« on: February 12, 2015, 09:37:52 PM »
I am running Mach3 on windows 7 64 bit.  I have a UC 100 motion controller.  Everything is wired according to the wiring diagram.  I cannot get a motor to turn during testing.  The computer is connected to the UC 100.  I have voltage at the signal side of the motor driver when I press the keyboard buttons to move the axis.

I am not sure what I am doing wrong but I cannot get the motor to turn with anything I try.

Please Help! 
Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
« Reply #1 on: February 13, 2015, 08:23:43 AM »
Contact UCCNC they have great customer service.
Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
« Reply #2 on: September 26, 2015, 07:03:28 PM »
jdlaw241,
can you provide any updates or findings that you may had made on this? That would be appreciated.

Cheers,
jay
Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
« Reply #3 on: September 28, 2015, 06:12:35 PM »
My problem ended up being defective hardware.  I had a bad board which wouldnt allow the signals to get to the drivers.  I replaced the board and one of the drivers and everything worked fine.