Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jdlaw241 on February 12, 2015, 09:37:52 PM

Title: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
Post by: jdlaw241 on February 12, 2015, 09:37:52 PM

I am running Mach3 on windows 7 64 bit.  I have a UC 100 motion controller.  Everything is wired according to the wiring diagram.  I cannot get a motor to turn during testing.  The computer is connected to the UC 100.  I have voltage at the signal side of the motor driver when I press the keyboard buttons to move the axis.

I am not sure what I am doing wrong but I cannot get the motor to turn with anything I try.

Please Help! 

Title: Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
Post by: geh7552 on February 13, 2015, 08:23:43 AM

Contact UCCNC they have great customer service.

Title: Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
Post by: jayybone on September 26, 2015, 07:03:28 PM

jdlaw241,
can you provide any updates or findings that you may had made on this? That would be appreciated.

Cheers,
jay

Title: Re: Mach3 Windows 7 64bit with UC100- NEED HELP!!!
Post by: jdlaw241 on September 28, 2015, 06:12:35 PM

My problem ended up being defective hardware.  I had a bad board which wouldnt allow the signals to get to the drivers.  I replaced the board and one of the drivers and everything worked fine.