Hello Guest it is December 07, 2024, 04:49:08 PM

Author Topic: G75 Request  (Read 3338 times)

0 Members and 1 Guest are viewing this topic.

G75 Request
« on: April 08, 2007, 02:45:34 PM »
Are there any plans to implement a G75 Grooving/Parting cycle in MachTurn?

Terry
Re: G75 Request
« Reply #1 on: April 08, 2007, 06:37:44 PM »
Not at this time :( We think that it should be done in Cam as we can take very large files :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com