Hello Guest it is April 19, 2024, 05:44:57 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: G75 Request  (Read 2697 times)

0 Members and 1 Guest are viewing this topic.

Offline mayhugh1

*
  • 39 39
    • View Profile
G75 Request
« on: April 08, 2007, 02:45:34 PM »
Are there any plans to implement a G75 Grooving/Parting cycle in MachTurn?

Terry
Logged

Offline Brian Barker

*
  • *
  • 3,859 3,859
    • View Profile
Re: G75 Request
« Reply #1 on: April 08, 2007, 06:37:44 PM »
Not at this time :( We think that it should be done in Cam as we can take very large files :)
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »