Hello Guest it is March 18, 2024, 11:35:22 PM

Author Topic: " no spindle feedback seen in G95 units/rev mode  (Read 2351 times)

0 Members and 1 Guest are viewing this topic.

" no spindle feedback seen in G95 units/rev mode
« on: January 17, 2015, 11:17:33 AM »


" no spindle feedback seen in G95 units/rev mode "
Hello Chaps

what is the cure for the above error message??

Is there a published list of error codes that I can access ?

regards

fred
think of the trees-- use both sides of the computer paper

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: " no spindle feedback seen in G95 units/rev mode
« Reply #1 on: January 18, 2015, 02:49:16 AM »
Do you have an index pulse from the spindle to Mach?
If not then that is why you get that message as it is looking for it and not seeing it so does not know if the rpm is as commanded.
Hood
Re: " no spindle feedback seen in G95 units/rev mode
« Reply #2 on: January 18, 2015, 10:06:09 AM »
thanks hood- i will check
think of the trees-- use both sides of the computer paper